Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

EEM Scripting

Hello All,

We have created an EEM script(attached it) in Lab, it worked fine. When we tried to implement it in Production router then the output of the action 2.0 comes out to be blank. The only difference b/w Production and Lab router is IOS. I have attached the o/p of working/non working. Any suggestion on this is highly appreciated.


LAB IOS : c3900-universalk9-mz.SPA.154-3.M3.bin

Production IOS : c3900-universalk9-mz.SPA.154-3.M4.bin

Regards

Shrikant

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

There are likely many more

There are likely many more differences between your lab and production.  I'm betting the configuration is very different.  Perhaps you have AAA in production and not in the lab.  If you do, the show command in question may not be authorized.  Try configuring your applet with "auth bypass" at the end of the applet line and see if that works as expected.

1 REPLY
Cisco Employee

There are likely many more

There are likely many more differences between your lab and production.  I'm betting the configuration is very different.  Perhaps you have AAA in production and not in the lab.  If you do, the show command in question may not be authorized.  Try configuring your applet with "auth bypass" at the end of the applet line and see if that works as expected.

48
Views
0
Helpful
1
Replies