I am using EEM to trigger the following commands on a set event:
action 1 cli command "enable"
action 2 cli command "tclsh flash:mytcl.tcl"
In my tcl script I am using the command 'after' to sleep for a specific time.
What I notice is that the script doesn't work consistently. Say I want to wait for 10 iterations and in each iteration sleep, sometimes it only does the first iteration, sometimes 2 and sometime 3 (3 was the max I got).
When I run the script via cli
It works fine every time.
When I removed the 'after' command it completed the iterations fine.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...