I tried to install the MIB file in my monitoring server to monitor and provide alert for the below snmp trap.I see the trap on the system but when i import the MIB file, there is no OID found in the MIB file to monitor. Can advise it is the correct file or something not right?
Attach is the mib files imported into the system except SNMPv2-CONF has error shown as below
There were actually two instances of this MIB created (sadly). The .134 instance is supported on NX-OS. The .91 is for IOS. You'll only need to be able to load one. So if you don't need the .134 instance, unload it and load the .91 version.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...