Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NX-OS EEM command/pattern option

Hello,

In IOS under EEM action we have command and pattern options to provide an imput based on specific pattern. I can not find that option in NX-OS. Is there any other syntax in NX-OS for similar application? Basically on a specific track down event I need to telnet to other NX-OS sytems and am trying to get it done using EEM on NX-OS. Any suggestions are appreciated.

Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

NX-OS EEM command/pattern option

Unfortunately, this is not possible on NX-OS.  EEM on NX-OS is EEM by name only.  The feature is very different than it is on IOS.  What you could do is use an IOS box as a proxy.  That is, send a trap using EEM from your NX-OS box, then have IOS do the telnet to the other NX-OS box to perform the necessary commands.

1 REPLY
Cisco Employee

NX-OS EEM command/pattern option

Unfortunately, this is not possible on NX-OS.  EEM on NX-OS is EEM by name only.  The feature is very different than it is on IOS.  What you could do is use an IOS box as a proxy.  That is, send a trap using EEM from your NX-OS box, then have IOS do the telnet to the other NX-OS box to perform the necessary commands.

465
Views
0
Helpful
1
Replies