Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Highlighted
New Member

Show interfaces transceiver - quick method (loop throw all interfaces with test)

Hello,

I try send informations about Tx and Rx about interfaces transceiver via syslog messages.

If I write command on CLI show interfaces transceiver the result running between 30-60 seconds with result (it's right):

....some headers...
mA: milliamperes, dBm: decibels (milliwatts).

Optical Optical
Temperature Voltage Tx Power Rx Power
Port (Celsius) (Volts) (dBm) (dBm)
--------- ----------- ------- -------- --------
Gi1/1/1 38.6 3.32 2.2 -12.0
Gi1/1/2 35.3 3.28 3.3 -14.5


SW01#

If I run the command show interfaces transceiver OR show interfaces transceiver | incl [0-9]/[0-9] the result running between 30-60 seconds too. And Event manager do not wait for result this long time if I run this query in EEM.

If I try run the query force the interface on CLI sh interfaces Gig 1/1/1 transceiver the result is extereme quick - this is right (exists monitor): 

Optical Optical
Temperature Voltage Tx Power Rx Power
Port (Celsius) (Volts) (dBm) (dBm)
--------- ----------- ------- -------- --------
Gi1/1/1 38.6 3.32 2.2 -12.0

If I try run the query force the interface on CLI sh interfaces Gig 1/0/12 transceiver the result is extereme quick - this is right (not exist monitor): 

Diagnostic Monitoring is not implemented.

I want write a EMM, where I go throw all physical interfaces (not VLANs and not Loopbacks) and on every interface I want run the force query and test result. If diagnostic monitor is implement, I want send syslog message.

Can you please help me with syntax? 
Green are my comments for you

event manager session cli username "tool_event_manager"
event manager applet PK_SHOWINTTRANS
event timer watchdog time 120 maxrun 120
action 001 syslog msg "PK_SHOWINTTRANS begin"
action 010 cli command "enable"
action 020 cli command "show interfaces transceiver | incl [0-9]/[0-9]"     // Read all interfaces on switch
action 030 foreach line "$_cli_result" "\n"         // Go throw all found interfaces in previous result
action 031 if $line eq "Ethernet"                    // If line (found interface) contains word Ethernet - it is physical interface
action 032 syslog msg "$line"             // send syslog message
action 033 end
action 060 syslog msg "PK_SHOWINTTRANS end"
!

Thank you and best regards,
 Petr

Everyone's tags (1)
193
Views
0
Helpful
0
Replies
CreatePlease to create content