Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Cisco Employee

SNMPv3 support

                   Is SNMPv3 supported in the EEM SNMP ED???  I need to use SNMPGETs to retireve specific information

from a modem and it only supports SNMPv3????

Everyone's tags (1)
6 REPLIES
Cisco Employee

SNMPv3 support

No, SNMPv3 is not supported for EEM operations.  Only v1 or v2c will work.

New Member

Has there been any movement

Has there been any movement on this?  Or is v3 still not supported?

Cisco Employee

As I recall, this thread was

As I recall, this thread was about doing polling from within an EEM policy.  No, this has not changed.  Only community-based SNMP is supported.  That said, we will be rolling out Python support for EEM in 16.5(1) for ISRs and Cat3850s, and it is possible to do more there with external scripts.  This still won't change the core EEM capabilities, though.

New Member

Sorry...I should have

Sorry...I should have specified.  I'm not so much interested in polling but the SNMP ED being able to read SNMPv3 authenticated & encrypted traps.  Based on your response though, I assume the same answer applies.

Cisco Employee

That depends more on the SNMP

That depends more on the SNMP manager built in to IOS than EEM.  I haven't tested this in a while.  Last I did, it did not work, but you might try it out with your code and see if that has changed.

New Member

 I did try and I could not

 I did try and I could not get it to work.  Even with v3 noauth I couldn't get it to work.  The receiving side debug simply stated that it was an invalid username despite the usernames matching.  

539
Views
0
Helpful
6
Replies