Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using "file size <>" in EEM script

Hi,

I'm working on a EEM script that saves logs to flash of the router and I'm trying to figure out a way to keep the file size under a certain limit to prevent the flash filling up from that one file. The problem now is that I'm not allowed to use the "file size <>" command in a EEM script. Anyway to get around this problem? I know this is because of the script is running in Safe-Tcl mode. Can I somehow get the scripts to run in a mode where I can use the "file size" command on a file I have created?

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Using "file size <>" in EEM script

In the EEM flavor of safe-tcl file stat is available.  You should be able to use that to get the file size.

Mike

1 REPLY
Cisco Employee

Using "file size <>" in EEM script

In the EEM flavor of safe-tcl file stat is available.  You should be able to use that to get the file size.

Mike

423
Views
0
Helpful
1
Replies