Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WAN Load Alarm Script Modification

Hello Joesph,

You may recall sometime ago I asked if it were possible to modify the attached script to allow for more than one interface. At the time you mentioned that it wasn't possible.

I was just wondering if you had created a script (or modified the existing script) that would send an alert when the utilization on more than one interface crossed a certain threshold?

Cheers

Carlton

1 REPLY
Cisco Employee

WAN Load Alarm Script Modification

Sorry, no.  This was not something I've been looking into.

753
Views
0
Helpful
1
Replies
CreatePlease to create content