cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1821
Views
0
Helpful
1
Replies

WAN Load Alarm Script Modification

Hello Joesph,

You may recall sometime ago I asked if it were possible to modify the attached script to allow for more than one interface. At the time you mentioned that it wasn't possible.

I was just wondering if you had created a script (or modified the existing script) that would send an alert when the utilization on more than one interface crossed a certain threshold?

Cheers

Carlton

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

Sorry, no.  This was not something I've been looking into.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: