CatTools works, just make sure you keep it from trying to enter enable mode before entering the commands you set. Also if you are trying to enter the command "mailconfig" you may need to enter the send-to email address on the same line as CatTools can't see the reply of the mailconfig command. Do the same thing with the "Y" option to show the passwords in MD5 instead of ****out for portability of the config.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...