The documentation states "The Security Management appliance pulls data for all reports from all managed appliances approximately every 15 minutes..... Depending on your appliance, it may take awhile for a particular message to be included in the reporting data on the Security Management appliance."
The reports that are to be taken by the SMA, rest on the ESAs and stay unavailable until they are pulled out by the SMA. I was wondering if it's possible to shorten the 15 minutes period by either configuring the SMA or the ESA in a different way. Since the addition of the SMA, 20 or so minutes of gap were reported between the SMA and the ESA.
Apart from that, is Cisco considering a cloud service as an alternative?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...