I have followed the SCCM deployment steps as well as tried other methods. I can not get the plugin to deploy without returning a ResultCode=-3 unless it is delployed to run as user, and they must have admin rights. Even usign run with administrative rights, only whn user is logged in it fails. Below is the command I'm currently trying through SCCM with no luck as well.
There have been some issues with SCCM deployment and certain versions of Windows. As such, it may be best to open a Service Request. This should allow the Cisco IronPort Customer Support team to gain specifics about your installation and envorionment. This can be done by clicking on the 'Open Service Request for thread' link, listed under the Actions menu on this page.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...