11-22-2013 05:59 AM
Bom dia prezados!
Alguem sabe ou já configurou "link aggregation" nos Ironport serie C(C-170 ou C-370)?
Funciona bem para redundancia de interface?
Grato
Wanderley
11-22-2013 06:09 AM
Translated:
Anyone know or have already configured "link aggregation" in Ironport C series (C-170 or C-370)?
Works well for redundancy interface?
11-22-2013 06:10 AM
My Portuguese is not that good but I think you are asking how to configure NIC pairing?
This is explained in the ESA user guide in a chapter called Advanced Network Configuration
In the version 8 manual it is chapter 33.
Basically it uses CLI command etherconfig
11-22-2013 07:21 AM
Hello David,
Thank you for your contribution, I will check the User Guide.
I want to pair the interfaces.
Thank you!
Att
Wanderley
11-22-2013 11:35 AM
Wanderley,
If you wish to send questions in Portuguese, I would recommend you to use the CSC Portuguese:
https://supportforums.cisco.com/community/portuguese/seguranca
In addition to David´s recommendation about the User Guide, I recommend the Technical Article below:
What is NIC pairing and how do I configure NIC pairing on my Email Security Appliance (ESA)?
Knowledge Base Answer ID: 268
http://tools.cisco.com/squish/7c3F5
In any case, as you can see, we will try to take good care of you in case you continue to use CSC English as well.
If you believe your got the information you were looking for, please mask the question as answered.
Regards,
Valter
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: