Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Outgoing Relay

Hi Everyone,

We have a setup in which users smtp auth to a MTA, this then relays the messages onto ironport to be sent.

All messages have headers added with the originating IP address of the sender. Some of these messages come from a webmail portal, but again are marked with the originating IP address of the user.

Unfortunately compromised credentials are a daily problem, which causes a flood of email from the offending senders.

Is there any way to limit or throttle senders based on the originating IP header instead of the MTA’s IP address ?

Many thanks in advance,

Everyone's tags (2)
1 REPLY
New Member

Outgoing Relay

Configure the MTA as an Incoming Relay on the Ironport - that should allow you to achieve what you're looking for.

430
Views
0
Helpful
1
Replies