Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Possible to have Physical and Virtual ESA Units in same cluster?

Given the dearth of information available on the virtual appliances, anyone have any ideas if it's possible to run a Physical C160 and a C300V running the same version of ASyncOS in the same cluster.  I need to migrate from physical to virtual and was evalualting the possbilty of migrating to the C300V's from the C160's by adding a C300V to a cluster then decomissioning the C160.

Anyone have any knowledge on this?

Thanks

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Possible to have Physical and Virtual ESA Units in same cluster?

Nathan -

Yes.  You can, as long as the appliance and the virtual appliance are running the same AsyncOS.  The 'clusterconfig' command will operate in the exact same fashion.  You'll just need to assure that your C300V has the featurekeys loaded in order to run cluster.

-Robert

2 REPLIES
Cisco Employee

Possible to have Physical and Virtual ESA Units in same cluster?

Nathan -

Yes.  You can, as long as the appliance and the virtual appliance are running the same AsyncOS.  The 'clusterconfig' command will operate in the exact same fashion.  You'll just need to assure that your C300V has the featurekeys loaded in order to run cluster.

-Robert

New Member

Possible to have Physical and Virtual ESA Units in same cluster?

Thanks for the info.  Much appreciated.

Nathan

933
Views
0
Helpful
2
Replies
CreatePlease login to create content