I've done a fair amount of googling, searching the IronPort KB as well as these forums and have not found a specific Voltage setting for powering the C150's. I've found references to Amp draw at different loads as well as an older document for a C10 saying something to the effect of 'anything from 110 to 240'.
Are the power supplies that versitle? Would you get more life out of a power supply running it at a specific Voltage rather than at some other hypothetical voltage?
I don't have any specific knowledge about the power supplies in a C150, but most modern power supplies are auto-ranging. If the C150 documentation doesn't mention input voltage, then don't worry about it. It'll work equally well anywhere in the 110 - 240 range.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...