04-25-2016 09:45 AM - edited 03-12-2019 05:59 AM
Hi all,
I can't see the ASA Firepower configuration TAB in ASDM however the ASA Firepower Status is added in ASDM Home TAB.
Regards,
Solved! Go to Solution.
04-27-2016 01:51 AM
Current, You need at least 6.0 version to be able to manage it via ASDM.
Check the release notes for 6.0
http://www.cisco.com/c/en/us/td/docs/security/firepower/60/relnote/firepower-system-release-notes-version-600.html
Search for "Expanded ASDM Management Availability"
Rate if it helps.
Thanks
Yogesh
04-26-2016 01:02 AM
Hi
That would mean that the PC where ASDM is running isn't able to communicate with firepower module.
Have you set up the firepower module with 1 of the following scenarios defined in this article.
http://www.cisco.com/c/en/us/support/docs/security/ips-sensor-software-version-71/113690-ips-config-mod-00.html#scenario1
Thanks
Yogesh
04-26-2016 01:35 AM
Hi yogdhanu,
Thank you for replying. In fact, i have no ip address or nameif in the management interface and it is connected to the Local Network behind the firewall.
Regards,
04-26-2016 02:28 AM
You just need to make sure that the management IP on firepower module is in same network as internal network and gateway can be some internal layer 3 device or ASA inside interface itself.
If the management interface is connected to local network behind firewall, your pc should be able to ping the firepower and vice versa. you can also try to telnet on port 443.
04-26-2016 09:53 AM
yes of course yagdhanu,
I can ping firepower management interface and telnet or ssh a session to it. But when connecting by ASDM, the TAB of Firepower MOdule configuration is not appeared
04-26-2016 10:07 AM
Hi
What's your ASA model and software version for both firepower and ASA ?
Unless you are using ASA 5506/5508/5516 with 5.4 (firepower software), you cannot use ASDM before 6.0 on any other ASA model.
So in other words ASA 5506/5508/5516 with 5.4 can be managed by ASDM. All other models of ASA-Firepower needs to run minimum of Firepower 6.0 code to be managed by ASDM.
04-27-2016 12:10 AM
Hi,
We have ASA5515-x with firepower module. The version of Firepwer module is 5.3.1.6 so we can't manage Firepower by ASDM?
Regards,
04-27-2016 01:51 AM
Current, You need at least 6.0 version to be able to manage it via ASDM.
Check the release notes for 6.0
http://www.cisco.com/c/en/us/td/docs/security/firepower/60/relnote/firepower-system-release-notes-version-600.html
Search for "Expanded ASDM Management Availability"
Rate if it helps.
Thanks
Yogesh
05-15-2018 07:44 AM
Upgrade Java RE to the latest version on your management PC.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide