This is not the first time i will configure over the internet access to a local server but this particular one is giving me a major headache and i thought to share the config with anyone who can help ppoint where the problem may be. While my NAT transalations seem to be working, when i attempt to browse the public IP, i am supposed to be routed to the local server, but this doesnt happen and i just get a blank page on my web browser. Please see config below:
Port forwarding statement seems to be Ok . have you performed basic troubleshooing ? checking if the port 80 is Up and running on server and got connectivity from router .you can also verify doing telnet on port 80.
Hi, thanks for your comments. I can telnet on port 80 fine. When I am on the LAN, I can browse to the server's local IP, however, when I attempt to navigate from outside the network through the 1 on 1 NAT, the browser just keeps trying to load and gets stuck there.
I tried this before but the issue remains the same. I just tried it again and same thing. Note that when specifying an interface instead of an IP, you cannot use the option "extendable" as it is not available.
I think the problem may be firewall or access list because the page does attempt to open, but the browser just gets stuck constantly trying to load the page.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...