Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2 OSPF process on asas5520

Hi

 

I have 2 OSPF process on my ASA5520 but have backbone areas, but there doesn't seem to be a way to allocate interface to specific OSPF processes.

 

I am running 8.4(7)

 

 

1 REPLY

hi,the OSPF exchange routes

hi,

the OSPF exchange routes on any ASA interface that falls within the address/network statement.

ciscoasa(config)# router ospf <pid>

ciscoasa(config-router)# network <network> <netmask> area <area-id>

 

OSPF authentication and other fine tuning can be done on the ASA interface.

ciscoasa(config)# interface gigabitethernet1
ciscoasa(config-if)# ospf ?

interface mode commands/options:
  authentication       Enable authentication
  authentication-key   Authentication password (key)
  cost                 Interface cost
  database-filter      Filter OSPF LSA during synchronization and flooding
  dead-interval        Interval after which a neighbor is declared dead
  hello-interval       Time between HELLO packets
  message-digest-key   Message digest authentication password (key)
  mtu-ignore           Ignores the MTU in DBD packets
  network              Network type
  priority             Router priority
  retransmit-interval  Time between retransmitting lost link state
                       advertisements
  transmit-delay       Link state transmit delay

30
Views
0
Helpful
1
Replies
CreatePlease login to create content