Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

415014: Maximum of 10 unanswered HTTP requests exceeded

Hi all

I am getting the following error

415014: Maximum of 10 unanswered HTTP requests exceeded

on an ASA

do you know what parameters I can change so the maximum unswered is more than 10.

Cheers

Arni

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 415014: Maximum of 10 unanswered HTTP requests exceeded

Hi,

This syslog message is generated in ASA,when the "http-map strict-http" command is configured and a more than unanswered 10 HTTP requests have been seen on a single connection.

Have look the following URL for the explanation.

http://www.cisco.com/en/US/products/ps6120/products_system_message_guide_chapter09186a008055fd2b.html#wp3047941

It appears that you cannot alter the number of attempts( 10), however you can configure the firwall to not drop the connection, if it exceeds 10 unanswered http requests.

Here's the URL from the command manual to alter the behavior of this command.

http://www.cisco.com/en/US/products/ps6120/products_command_reference_chapter09186a00805fb9e9.html#wp1108886

Hope this helps. Kindly rate the post if it was helpful.

-VJ

1 REPLY

Re: 415014: Maximum of 10 unanswered HTTP requests exceeded

Hi,

This syslog message is generated in ASA,when the "http-map strict-http" command is configured and a more than unanswered 10 HTTP requests have been seen on a single connection.

Have look the following URL for the explanation.

http://www.cisco.com/en/US/products/ps6120/products_system_message_guide_chapter09186a008055fd2b.html#wp3047941

It appears that you cannot alter the number of attempts( 10), however you can configure the firwall to not drop the connection, if it exceeds 10 unanswered http requests.

Here's the URL from the command manual to alter the behavior of this command.

http://www.cisco.com/en/US/products/ps6120/products_command_reference_chapter09186a00805fb9e9.html#wp1108886

Hope this helps. Kindly rate the post if it was helpful.

-VJ

192
Views
0
Helpful
1
Replies
CreatePlease to create content