Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

515 E UR 6x to 7x upgradation problem

After issuing the command copy tftp flash on the secondary PIX it is showing on the tftp server that transfer of the image completed. But on the session output of the pix is showing nothing like "image install". When try to reload the pix giving the error" copying the image can not reload".Please suggests on that. In this case if I power off /on the secondary pix what will be the effect whether the pix boot up with the old verson.

6 REPLIES
Cisco Employee

Re: 515 E UR 6x to 7x upgradation problem

do a sh flash..do you see new image installed ?

also check sh run | inc boot, the firewall will boot with the boot image you have set

New Member

Re: 515 E UR 6x to 7x upgradation problem

No sh flash command is taken by the firewall.

New Member

Re: 515 E UR 6x to 7x upgradation problem

No sh flash command is taken by the firewall.

Cisco Employee

Re: 515 E UR 6x to 7x upgradation problem

okie..then you are on 6.x..reload the box and try again to upgrade form tftp..which mode of firewall is it ?

New Member

Re: 515 E UR 6x to 7x upgradation problem

You mean to say power off/on. As the reload command is also not taking by the box.giving the error "can not relaod..writing emage"

New Member

Re: 515 E UR 6x to 7x upgradation problem

boot in Monitor mode , upgrade OS

thanks

karthik

125
Views
5
Helpful
6
Replies