Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

5510 active-standby failover

I have two new ASA 5510s, with 7.2(2)10 configured for active/standby failover.

due to ASA interface limitation/availability, I am using only one interface for both LAN-base and stateful failover:

interface Ethernet0/3

speed 100

duplex full

!

interface Ethernet0/3.2

description LAN Failover Interface

vlan 20

!

interface Ethernet0/3.3

description STATE Failover Interface

vlan 30

failover is working, but I'm concern that when I enter “show failover” the firewalls don't see each other

any help?

thanks, kevin

3 REPLIES

Re: 5510 active-standby failover

First of all you don't need sub-interfaces if you share the Failover/Stateful interface(s). Just use Eth0/0.

Secondly is it possible to post the output of 'show failover? and if possible show run failover.

Regards

Farrukh

New Member

Re: 5510 active-standby failover

Farrukh, I messed and didn't use:

failover key xxxxx

once I entered the key, on both, sync' come right up and all works now

thanks, for responding

kevin

Re: 5510 active-standby failover

No problem, glad you have it working now.

Regards

Farrukh

130
Views
0
Helpful
3
Replies
CreatePlease login to create content