5585x Pri Unit Interfaces stuck in Unknown (Monitored) state from more than 3 hrs
Need urgent help on belpw.
we upgrade asa 5585x from 8.2.x Ios to 8.4 & then 9.2.
while config sync , it showed sync completed to standby but pri unit interfaces stuck in Unknown (Monitored) state.
we comparied config with standby & replication is happed properly & connction state table is also maintained with standby & from pri tarffic is flowing normally....I need to make failover state health asap
we need advise on what could be cause & next action.
COGINCHNTCODCINTF1(config)# sh fail
Failover unit Primary
Failover LAN Interface: failover GigabitEthernet0/6 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 5 seconds, holdtime 25 seconds
Interface Policy 1
Monitored Interfaces 10 of 1025 maximum
Version: Ours 9.0(2), Mate 9.0(2)
Last Failover at: 10:10:31 IST Nov 10 2013
This host: Primary - Active
Active time: 23872 (sec)
slot 0: ASA5585-SSP-20 hw/sw rev (2.0/9.0(2)) status (Up Sys)
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...