I have two 6503's with Sup720's and FWSM's in and want to create a VPN tunnel from their poistion to our office here. I have a dedicated router here but would like to know where you suggest I terminate the tunnel at the 6503 end?
From what I've read it looks as though I can't do it on the FWSM's, which was going to be my place of choice! Is this definitely the case?
If I do it on the MSFC how will it work if one switch goes down? Do I need to create a HSRP address and set the tunnel up using that to solve any failover issues or is there a better way?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...