I am working on TACACS authentication in PIX and FWSM. I noticed that even with giving a user Privilege 15 access in Cisco ACS, i am prompted for enable password when i type en. But for switches / routers, it only prompts me for password once and directly takes me to privilege mode. But for PIX and FWSM, i am taken to user mode first.
Is this some limitation? Is there any workaround to this.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...