Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access list.

I am trying to configure ACL for remote location, accessing one of application on specific port. At remote side they have created a VLAN (e.g. 11.1.x.x) and at main office inside VLAN is 11.2.x.x. I have added route(ip of remote router) to pix and applied this ACL to the outside interface. But the remote user is unable to access application.

For example:

access-list inside_acl 11.1.0.0 255.255.255.0 host 11.2.0.1 eq 23678

where,

11.1.0.0=> remote network

11.2.0.1=> server/host at main office

I am confused whether to apply this acl to Inside interface or Outside interface.

4 REPLIES
Hall of Fame Super Blue

Re: Access list.

Hi

You need to apply this on the outside interface of your pix in the inbound direction as the user is in the remote office and is sending traffic to your vlan.

Be aware that there is an implict deny at the end of each access-list so if you apply that access-list as is it will only allow port 23768 from vlan 11.1.x.x through.

HTH

Jon

Silver

Re: Access list.

Create it as a Extended permit, it should work.

access-list 100 extended permit tcp 172.16.1.0 255.255.255.0 10.1.1.0

255.255.255.0 eq 2000

and put it as on interface as a Outbound.

Regards,

Dharmesh Purohit

Silver

Re: Access list.

See same as you are asking on below Link.. ACL EXAMPLES:

http://www.netcraftsmen.net/welcher/papers/pix02.html

REgards,

Dharmesh Purohit

New Member

Re: Access list.

Dear All,

Thanks...

124
Views
0
Helpful
4
Replies