Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access to only one protocol at a time?

I have only 1 outside address, and I PAT to several inside addresses. But only one protocol works inside. I can connect to port 80 but not 25.

ip nat inside source static tcp X.X.X.C 25 interface FastEthernet4 25

ip nat inside source static tcp X.X.X.A 80 interface FastEthernet4 80

##I have omitted lines to save space.###

access-list 101 permit tcp any any eq smtp

access-list 101 permit tcp any any eq 80

Can someone point me in the right direction?

1 REPLY
Hall of Fame Super Blue

Re: Access to only one protocol at a time?

Hi

Try adding the keyword "extendable" to the end of both of your nat statements eg.

ip nat inside source static tcp X.X.X.C 25 interface FastEthernet4 25 extendable

HTH

Jon

109
Views
0
Helpful
1
Replies