Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Active / Active, active / stadnby asa 5510

Hi,

We are trying to build a security zone with 4 firewalls and a physical dmz.

fw 1 and fw 2 are on the left side, then a 2 switches and 2 microsoft firewalls on the right side. All are supposed to connected redundant to each other. fw 1 and fw2 are asa 5510. both 5510 firewalls are supposed to be active / active. One question i have is, the firewalls on the right side to what ip do they need to connect for the default route? Does the asa 5510 has some kind of vrrp for the inside interface?

Best regards

Jorg

1 REPLY
Bronze

Re: Active / Active, active / stadnby asa 5510

refer the PIX/ASA : Active/Active Failover Configuration guide in the following link for better understanding of the configuration:

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080834058.shtml#tab2

602
Views
0
Helpful
1
Replies
CreatePlease to create content