Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Active/Active and Active/Passive Distance

Hi, 

 

I have got my sever in two location. They are in location between the distance of about 2 KM. I have got a fiber connectivity between these two location. I want to get the HA environment on ASA 5515. How can I maintain the active/active or active/passive if the distance is 2 KM ? Can I get the HA environment or not ?

 

Thanks in advance for your kind support.

 

Mero  

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

As long as your latency is 10

As long as your latency is 10 ms or less you should be OK. Anything higher may degrade the reliability due to delay in receiving failover messages. 250 ms is the absolute maximum allowed. This is specified in the Configuration Guide.

1 REPLY
Hall of Fame Super Silver

As long as your latency is 10

As long as your latency is 10 ms or less you should be OK. Anything higher may degrade the reliability due to delay in receiving failover messages. 250 ms is the absolute maximum allowed. This is specified in the Configuration Guide.

55
Views
0
Helpful
1
Replies
CreatePlease login to create content