Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

active/active Fail over monitoring

Guys,

I have a small concern for my Active active FO. Below are the details of setup.

1)- I have two pairs of ASA 5520 each carrying three contexts. (CTXT 1-3 in 1st ASA, CTXT 4-6 in 2nd ASA).

2)- I have created two fail over group in each ASA for active active FO. FO group 1&2 in primary ASA and 3&4 FO group in 2nd ASA.

3)- I have assigned two contexts (CTXT1-2) to FO group 1 and rest Context (CTXT-3) to FO group 2 in primary ASA.

4)- Same in the 2nd ASA.

My question is

1)- how can i configure my monitor for fail over.

2)- Is it based on the Interfaces of Contexts or the no of contexts ?

Thanks

swap

117
Views
0
Helpful
0
Replies