Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Active/Standby Failover ASA 5520

Hi

I have a pair of asa5520 configured as active/standby failover pair.

I have a requirement to carry UDP video conferencing sessions through my firewall.

During testing I made a video call from a unit on the inside to the outside. The call establishes fine.

I then Fail and interface on the active/Primary unit, the standby becomes active and the remains up (image freezes for 5 secs, which is fine).

If I reconnect the interface on the primary, wait a minute or two and fail an interface on the active/Secondary unit, the call freezes for 5 secs and then resumes.

After approx 60 secs running on the active/Primary the call drops?

I this right?

The video call is a standard H323 call using Tanberg units.

2 REPLIES
New Member

Re: Active/Standby Failover ASA 5520

Can you post your failover config ? Failover should be stateful for H323.

New Member

Re: Active/Standby Failover ASA 5520

It works fine when I turn off the h323 inspection rule

181
Views
0
Helpful
2
Replies