Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Active/Standby Failover Config change

Hi everyone,

This weekend we are doing some change on ASA in Active/Standby mode.

We will power off standby ASA.

Do some changes on Active ASA  save the changes  and reboot it.

Power up the Active ASA and will test  the connectivity if it is working  or not .

In case Active ASA is not working as expected after the change i will power it off.

Power up Standby ASA  then it will become active as expected.

Now if i Power up other ASA where changes were made will  it synchnorize to old config from Standby  ASA or  not?

Last week we did some changes on Active ASA and it did not work as expected so we have to undo our change.

Need to make sure our backup plan is working?

Regards

Mahesh

  • Firewalling
1 ACCEPTED SOLUTION

Accepted Solutions

Re: Active/Standby Failover Config change

In your fall back scenario you would have to tell what was the secondary ASA that it is now the primary

change

failover lan unit secondary

to

failover lan unit primary

and vice-versa on the now primary ASA.

change

failover lan unit primary

to

failover lan unit secondary


Hope it helps      

2 REPLIES

Re: Active/Standby Failover Config change

In your fall back scenario you would have to tell what was the secondary ASA that it is now the primary

change

failover lan unit secondary

to

failover lan unit primary

and vice-versa on the now primary ASA.

change

failover lan unit primary

to

failover lan unit secondary


Hope it helps      

New Member

Active/Standby Failover Config change

Many thanks Collin

MAhesh

158
Views
0
Helpful
2
Replies
This widget could not be displayed.