add network group object with ip range in cisco asa
I have a asa5510 with asa ver7.2. I would like to know if its possible to add a network group object specifying ip address range eg 192.168.0.1-192.168.0.100 instead of specify the entire subnet. I have explore the asdm and it seem the only way is to add the addresses 1 by 1 into the network group object. Is there a more efficient way? Pls advise. Thks in advance.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...