Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

After convertion to 8.4.2 code

Hi All,

I have converted an appliance from ASA 7.2 to 8.4.2

Everything is working but I was wondering if I can delete the following configuration lines in the code.

In 7 code we were using 'names' but now is everything refrenced to objects. Can we delete the 'names' without any problems.

regards,

Sander

1 ACCEPTED SOLUTION

Accepted Solutions

Re: After convertion to 8.4.2 code

Hello Sander,

Yes, you can delete the names without any problems, it is not going to afect the configuration as the ASA is now using object groups for that.  Just place the no in front of the line and that should do it,

Regards,

Julio

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
1 REPLY

Re: After convertion to 8.4.2 code

Hello Sander,

Yes, you can delete the names without any problems, it is not going to afect the configuration as the ASA is now using object groups for that.  Just place the no in front of the line and that should do it,

Regards,

Julio

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
167
Views
0
Helpful
1
Replies
CreatePlease login to create content