Hi,
Recently our company has bought two Cisco ASA 5515-X firewalls for at our datacenter. I am new on configuring a Cisco ASA but sofar things are looking good. I have configured them both with HA (active/active) in multiple context mode. Currently they host two security contexts.
I want to configure VPN Client functionallity for Remote Access. As far as I know they come with two user licenses. But there is no VPN Client wizard available and I can't find a way to enable it.
- Is VPN Client supported in Multiple Context mode?
- What is AnyWhere Essentials vs Premium Peers?
Boudewijn
Here is some additional output fromt he current configuration:
Cisco Adaptive Security Appliance Software Version 9.1(2) <context>
Device Manager Version 7.1(3)
Encryption hardware device : Cisco ASA-55xx on-board accelerator (revision 0x1)
Boot microcode : CNPx-MC-BOOT-2.00
SSL/IKE microcode : CNPx-MC-SSL-PLUS-T020
IPSec microcode : CNPx-MC-IPSEC-MAIN-0024
Number of accelerators: 1
Baseboard Management Controller (revision 0x1) Firmware Version: 2.4
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited perpetual
Maximum VLANs : 100 perpetual
Inside Hosts : Unlimited perpetual
Failover : Active/Active perpetual
Encryption-DES : Enabled perpetual
Encryption-3DES-AES : Enabled perpetual
Security Contexts : 2 perpetual
GTP/GPRS : Disabled perpetual
AnyConnect Premium Peers : 2 perpetual
AnyConnect Essentials : Disabled perpetual
Other VPN Peers : 250 perpetual
Total VPN Peers : 250 perpetual
Shared License : Disabled perpetual
AnyConnect for Mobile : Disabled perpetual
AnyConnect for Cisco VPN Phone : Disabled perpetual
Advanced Endpoint Assessment : Disabled perpetual
UC Phone Proxy Sessions : 2 perpetual
Total UC Proxy Sessions : 2 perpetual
Botnet Traffic Filter : Disabled perpetual
Intercompany Media Engine : Disabled perpetual
IPS Module : Disabled perpetual
Cluster : Disabled perpetual
This platform has an ASA 5515 Security Plus license.
