04-13-2015 07:26 AM - edited 03-11-2019 10:45 PM
I have an ASA-5510 with double "outside" connection (two different provider).
The "primary" connection has the default route to outside interface, but I need to NAT some machines on the "secondary" interface.
I configure the NAT, but I do not have response; I can have response only by configuring a static route.
As show by the Cisco documentation, the NAT can automatically solve the EGRESS interface, but here it seems to NOT work
I remember a similar scenario, where I solved the throuble by removing the "IP reverse path verify" command.
But in that case the firmware was an 8.4.x and now it is a 9.1.5
Some suggestion ?
Thanks in advance,
Claudio
04-14-2015 04:33 AM
If policy based routing can help you in achieving your requirement then you may try ASA9.4 which supports PBR.
Hope it helps.
04-15-2015 01:21 AM
Hi,
Agree with Rishabh and the only workarounds possible are listed in this documents:-
https://supportforums.cisco.com/document/59986/loadbalancing-dual-isp-asa
https://supportforums.cisco.com/document/49756/asapix-load-balancing-between-two-isp-options
Thanks and Regards,
Vibhor Amrodia
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide