Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA 5500-X RFC3069

Hello,

is there a way to configure RFC3069-Support on ASA 5500-X?

 

I would like to do this:

     http://www.gossamer-threads.com/lists/nsp/ipv6/25933

But i would like to add some firewall support (ACLs and so on) .

 

Best regards

 

Harald

Everyone's tags (1)
1 REPLY
VIP Purple

I think that it's not

I think that it's not possible natively. But there could be two ways to achieve the same thing, but it's questionable if these ways match your needs:

  1. On the ASASM there are private VLANs supported which could give you the needed functionality. Ok, the pricetag is a "little" higher than a 5500-X.
  2. If you don't mind adding a lot of complexity and some additional licensing cost, then you could achieve a similar thing through virtual contexts. The customers each get a transparent context to an external router or a cascaded routed-context.

If you find any other solution, please post them here. I'm also searching for a suitable solution for a hosting-environment where we don't want to waste that much IP-addresses.


--
Don't stop after you've improved your network! Improve the world by lending money to the working poor: http://www.kiva.org/invitedby/karsteni
27
Views
0
Helpful
1
Replies
CreatePlease to create content