We're using an ASA-5505 and have switched to a DSL line that uses an ActionTec m1000 modem. To pass the static IP block straight through to the ASA the modem needs to be in bridging mode - but when it is a straight pass-through the modem does not send the ISP the PPP username and password to authenticate. Is there a way to configure the ASA to send the user name and password? Thanks!
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...