ASA-5505 appears to be correctly configured, but will not pass traffic out.
This seems to be a common issue with a number of threads, but I've yet to find an issue. The setup is very simple. An ASA-5505 (8.4.7) with a single static IP sitting behind a Comcast Business Modem that is configured for bridge mode. I'm an I.T. person with about 10 years experience with moderate exposure to command line in general and passing experience with Cisco IOS CLI. I'm also really embarrased that I can't figure out a simple setup such as this. Any guidance is appreciated. Here is the running config:
ASA Version 8.4(7)
enable password 8Ry2YjIyt7RRXU24 encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
switchport access vlan 2
ip address 192.168.0.1 255.255.255.0
ip address xxx.xxx.xxx.81 255.255.255.248
boot system disk0:/asa847-k8.bin
ftp mode passive
dns domain-lookup inside
dns domain-lookup outside
dns server-group DefaultDNS
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
no arp permit-nonconnected
nat (inside,outside) after-auto source dynamic any interface
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...