Hi I've been battling with my new ASA 5505 and set it up based on the Cisco configuration example. It's a basic Internal network setup. I can get out onto the Internet fine but the setup will not allow anyone in via the NAT and access rules. Can anyone tell me what am I doing wrong? Thanks in advance.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...