I have an ASA 5505 and I'm having a couple of issues and I need some help with something.
First, I have a computer on the network that will not connect to the internet when I set the IP manually. If it connects to the ASA via DHCP, it works fine, but manually it fails. What can I do to fix this?
Also, this computer needs to have a few ports sent to it, to make it "open". I am using ASDM and have no clue how to get this to work. Any help would be great.
First, let computer obtain IP from DHCP. Then Start>Run>Cmd>ipconfig /all . Note down the acquired IP address, gateway! subnetmask and DNS! addresses, and try assigning these values manually.
"Also, this computer needs to have a few ports sent to it, to make it "open". I am using ASDM and have no clue how to get this to work" please describe what you want to achieve, you want this internal IP to be reached from outside using a public IP (Port forwarding) ?
No DHCP wont mess up. But my personal advise is not using Cisco DHCP, since you can not make reservations. Now you can assign the IP address that you btained from DHCP manually, and can use it without any problem untill its lease expires.
Do you have a specific public IP to be one-to-one natted to internal client or you want to use the outside interface IP?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...