Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

asa 5505 DURING set up lost contact with unit

did setup iaw instructions. got to step 9 where it went into configure mode.  last few messages 

192.168.1.5 to 192.168.1.1 (BUILT IN BOUND TO TO IDENTIFY),   then

192.168.1.5 START SSL HANDSHAKE FOR TLSW1 SESSIN, THEN

192.168.1.5 COMPLETED HANDSHAKE, THEN

LOGIN PERMITED FROM 192.168.1.5 TO 192.168.1.1/HTTPS,THEN

BEGIN CONFIGURATION 192.168.1.5 READY FROM HTTP(POST), THEN

USER ENABLE_15 EXECUTED THE INTERFACE VLAND1 CONNECT,

THE CONNECTION LOST.

NOW I am UNABLE TO DO ANYTHING WITH THE 5505.  CAN NOT LOG IN , CAN NOT GET A PING OF 192.168.1.1, CAN NOT GET INTO THE UNIT AND DO A FACTORY RESET

WHAT TO DO NEXT??????????

3 REPLIES
New Member

asa 5505 DURING set up lost contact with unit

try https://192.168.1.5 from browser of your comp or if you already have ASDM

New Member

asa 5505 DURING set up lost contact with unit

already tried that and many others that were sited in the log

next i will try the blue wire.  I had to go to another building to find an old computer with that type of port.

thanks for trying

waiting for a correct answer!!!!!!!!!!!!!!!

Cisco Employee

asa 5505 DURING set up lost contact with unit

Hello Linda,

Do you have console access? If you do, try to go to enable there and type "clear config factory" that should bring the factory defaults.

If you are not able to enter to enable mode (password by default is cisco or blank (type enter)) then you may need to do a password reset on the device and then get there.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_password_recovery09186a008009478b.shtml

Let me know if  you still have problems.

Mike

Mike
249
Views
0
Helpful
3
Replies
CreatePlease login to create content