Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Asa 5505 newbie question (outside static and NAT)

Hi everybody,

First of all let me tell you that I'm totally new with Cisco firewalls. I have experience for Watchguard only.

I need to configure firewall to use static IP for outside network. With wizard I can configure ASA to use DHCP for outside network and everything goes fine but when I try to configure ASA to use static IP I can't connect to outside world anymore.

There is a router from ISP between ASA and internet and it uses static IP 81.209.97.9. I need to configure ASA to use IP 81.209.97.10 for outside interface.

Can you tell me the steps to do this? Can it be done in ASDM or do I need console connetion? Should I create static route between router and firewall or how do I tell firewall the IP of the router?

Thanks

Juha

1 REPLY
Cisco Employee

Re: Asa 5505 newbie question (outside static and NAT)

Just found this link. Very simple and easy to follow. Only 6 steps.

http://ezinearticles.com/?Basic-Configuration-Tutorial-For-the-Cisco-ASA-5505-Firewall&id=1681858

You basically need the following.

route

permission

translation

to allow traffic through any firewall.

-KS

186
Views
0
Helpful
1
Replies