Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5505 Syslog configuration.

syslog configuration.

unable to getting logs from server.....

I am getting error in ASA5505-FW#sh logging as mentioned below.

May 29 2009 02:08:19 : %ASA-3-710003: TCP access denied by ACL from to inside:


Re: ASA 5505 Syslog configuration.

Where are your acl's at on the firewall? Do you have your firewall configured in transparent mode?



HTH, John *** Please rate all useful posts ***
Cisco Employee

Re: ASA 5505 Syslog configuration.

May 29 2009 02:08:19 : %ASA-3-710003: TCP access denied by ACL from to inside:

So you are unable to telnet from PC to the ASA's inside interface You do not have the line "telnet 0 0 inside"

You need help with that or do you need help with configuring a syslog server.

Flow this link for configuring syslog server.

If you need assistance to configure the asa for telnet access pls. read here.

New Member

Re: ASA 5505 Syslog configuration.

I have done the configuration as per the ulr.The same error is getting. Please check the configuration and confirm anything needs to update.

interface Vlan1

nameif inside

security-level 100

ip address


interface Vlan2

nameif outside

security-level 0

ip address


interface Vlan3

no nameif

no security-level

no ip address


interface Ethernet0/0

switchport access vlan 2


interface Ethernet0/1


ftp mode passive

clock timezone IST 5 30

dns server-group DefaultDNS

domain-name default.domain.invalid

access-list 100 extended permit tcp any host eq 3389

access-list 100 extended permit icmp any any echo-reply

access-list 100 extended permit tcp any host eq 445

access-list 100 extended permit tcp any host eq telnet

access-list 100 extended permit tcp any host eq ftp

access-list nonat extended permit ip any

access-list split_tunnel standard permit

pager lines 24

logging enable

logging timestamp

logging standby

logging console alerts

logging monitor informational

logging buffered errors

logging trap errors

logging history emergencies

logging asdm informational

logging mail alerts

logging device-id ipaddress inside

logging host inside

mtu inside 1500

mtu outside 1500

ip local pool vpnpool mask

ip audit attack action

icmp unreachable rate-limit 1 burst-size 1

asdm image disk0:/asdm-524.bin

no asdm history enable

arp timeout 14400

global (outside) 1 interface

nat (inside) 0 access-list nonat

nat (inside) 1

static (inside,outside) netmask

access-group 100 in interface outside

route outside 1

timeout xlate 3:00:00

timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02

timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00

timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00

timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute

http server enable

http outside

http inside

snmp-server host inside community Airtel

no snmp-server location

no snmp-server contact

snmp-server community Airtel

snmp-server enable traps snmp authentication linkup linkdown coldstart

snmp-server enable traps syslog

crypto ipsec transform-set airtel esp-3des esp-sha-hmac

crypto dynamic-map bharti 10 set transform-set airtel

crypto dynamic-map bharti 10 set security-association lifetime seconds 288000

crypto dynamic-map bharti 10 set reverse-route

crypto map bharti 10 ipsec-isakmp dynamic bharti

crypto map bharti interface outside

crypto isakmp enable outside

crypto isakmp policy 1

authentication pre-share

encryption 3des

hash sha

group 2

lifetime 43200

crypto isakmp nat-traversal 20

telnet inside

telnet timeout 30

ssh outside

ssh timeout 5

console timeout 0

dhcpd auto_config inside


ntp server

group-policy VPNclient internal

group-policy VPNclient attributes

dns-server value

vpn-tunnel-protocol IPSec

split-tunnel-policy tunnelspecified

split-tunnel-network-list value split_tunnel

default-domain value

username manju password sa8Cy29xTh/4YFVH encrypted

tunnel-group IPsecVPN type ipsec-ra

tunnel-group IPSecVPN type ipsec-ra

tunnel-group VPNclient type ipsec-ra

tunnel-group VPNclient general-attributes

address-pool vpnpool

default-group-policy VPNclient

tunnel-group VPNclient ipsec-attributes

pre-shared-key *


class-map inspection_default

match default-inspection-traffic


policy-map type inspect dns preset_dns_map


message-length maximum 512