Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASA 5505 VPN RA help

Trying to configure remote access via Preshared secret..VPN client connects fine, but I am unable to connect to the internal LAN. When I turn on logging it is complaining that I have no translation rule outside interface to internal LAN. I have tried bypassing NAT via NAT 0 and ACL but no success.

Any ideas ??

Thanks Dave

2 REPLIES
Gold

Re: ASA 5505 VPN RA help

so your nat 0 statement/acl has your LAN network range for the source address and your vpn client address range for the destination part?

is sysopt connection permit-vpn/ipsec turned on?

(sh run sysopt)

if not, is your outside-to-inside ACL allowing access from the remote access address range?

New Member

Re: ASA 5505 VPN RA help

Thanks, it was the Nat 0 acl, had to swap it around and make the source address the internal LAN.

Cheers

Dave

105
Views
0
Helpful
2
Replies
CreatePlease to create content