Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA 5510 default user&pass not working

All,

I just got a ASA 5510 out of the box and the default user&pass are not working.

Imagine now I cant login!

Vlad

Dont take it in consieration.

We reset the password...

1 REPLY
Community Member

Re: ASA 5510 default user&pass not working

If it's anything like a 5505, when you take it out of the box the first thing you should do is connect to it via the console cable. Hook it up to your asa and the other end to your laptop and use HyperTerminal or Putty to connect to the device via serial (9200, Hardware control none)

You should be presented a prompt ">" and then type ena [enter]

This should get you to the enable prompt, without using a single password.

564
Views
0
Helpful
1
Replies
CreatePlease to create content