Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Asa 5510 Dual Isp

I have 2 Isp's connected to my Asa 5510 running 8.4.4 Ios. Can I route Dmz traffic out one Isp and my regualr traffic out the other Isp?

4 REPLIES
Red

Asa 5510 Dual Isp

Hi bmurray,

We were just having the same discussion on this thread, you can also follow the same:

https://supportforums.cisco.com/thread/2124210?tstart=0

I guess your setup as well has the same requirement, you can follow the doc in there for the workaround.

Please be sure that it is not supported on the ASA but just a workaround.

Thanks,

Varun

Thanks, Varun Rao Security Team, Cisco TAC
New Member

Asa 5510 Dual Isp

I wonder if I can manage to find a solution for  ASA 8.3+; literally everything that adresses this issue deals with pre-8.3 code, mostly 7.

Red

Asa 5510 Dual Isp

Hi Dan,

I have had it working in one of my cases earlier, but it depends a bit on your requirement, can you explain me yours???

Thanks,

Varun

Thanks, Varun Rao Security Team, Cisco TAC
New Member

Re: Asa 5510 Dual Isp

Varun,

sure; I have sketched out the desired scenario here: https://supportforums.cisco.com/message/3512132.

I have worked around this by terminating the line on a 2611XM plugged before the ASA, but I am still scouring around for a solution ( at least until PBR is introduced formally to the ASA ).

I have learned that NAT processing precedes the routing decision, so there MUST be some tweak, at least sort of....

651
Views
5
Helpful
4
Replies
CreatePlease to create content