Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5510 - Enable / Configure SIP

We are about to test VOIP solutions and have been advised that we need to enable SIP on our ASA 5510's in each site.

Are there instructions on how to enable SIP?

1 REPLY
Cisco Employee

Re: ASA 5510 - Enable / Configure SIP

Hi,

Here is a link explaining the function for the SIP inspection:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/conf_g

d/firewall/inspect.htm#wp1204403

And here is how to configure modular policy:

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/conf_g

d/firewall/mpc.htm

Example for that if you want to enable sip inspection for traffic between 10.0.0.0 and

192.168.0.0 networks, below is a sample configuration.

********************************************

access-list inspection permit ip 10.0.0.0 255.0.0.0 192.168.1.0 255.255.255.0

class-map sip_inspect

match access-list inspection

exit

policy-map mypolicy

class sip_inspect

inspect sip

exit

exit

service-policy mypolicy global

********************************************

Regards,

Arul

*Pls rate if it helps*

1285
Views
9
Helpful
1
Replies