Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5510 Failover Issue

Hey all,

I'm trying to configure failover on a pair of ASA 5510 firewalls. Both are running Security Plus Licenses. How I have know PIX and ASA failover to work is that each interface on both firewalls have addresses on the same subnet and the addresses that is functional is that of the primary. When I issue a 'show failover' on both ASA in my current scenario the Standby address for all interfaces appear as 0.0.0.0. The failover interface that I am using is Ethernet0/3. See attached output which as the following obtained from a console session:

1. show version

2. show fail

3. show run fail

4. show fail interface

Any thoughts??

-lloyd

1 REPLY
Silver

Re: ASA 5510 Failover Issue

Use the show failover state command to verify the state.

146
Views
0
Helpful
1
Replies