Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

ASA 5510 not loading after software update

Due to Advisory ID: cisco-sa-20090408-asa, I have tried to update a new ASA 5510 from asa708-k8.bin to asa812-19-smp-k8.bin, asa804-28-k8.bin, and asa804-k8.bin

Each time I tftp the new image across, and modify the system boot entry to boot the new image first.

i.e.

boot system disk0:/asa804-k8.bin

boot system disk0:/asa708-k8.bin

However when the ASA boots it starts to load the new image, but it just sits there. No messages from the console. it just sits there. Is this a licensing activation issue, are are the images being corrupted somehow?

Launching BootLoader...

Boot configuration file contains 2 entries.

Loading disk0:/asa804-k8.bin... Booting...

Loading...

3 REPLIES
Anonymous
N/A

Re: ASA 5510 not loading after software update

New Member

Re: ASA 5510 not loading after software update

** SOLVED **

It's not a licensing issue.

Apparently you may need to do an incremental upgrade, from one mainline release(i.e. 7.2) to another(i.e 8.0). This is due to prerequisite features that must be running before changing trains.

I upgraded from 7.0(8) to 7.2(4) to 8.0(4).

New Member

Re: ASA 5510 not loading after software update

double post

428
Views
0
Helpful
3
Replies
CreatePlease to create content